Ridge Carbide TS2000 10" 40T Full Kerf Box Joint Blade with Flat Bottom Grind

Please Note: This blade is for box joints, kerf cutting and ripping only.  Better results for general purpose use will be obtained by the standard TS21040.

The TS21040FT version of the popular TS2000 series of saw blades has the raker tooth even with the ATB teeth.  For those that are looking to kerf cut or make make box joints this is the blade for you.  If you are looking for the standard general purpose blade you want the TS21040.

The American Made Ridge Carbide TS2000 series saw blade is a premier award winning general purpose saw blade. General purpose saw blades are made to replace ripping and crosscutting blades and nothing leaves a smoother cut than the Ridge Carbide TS2000 with is finely ground carbide teeth.

Fine Woodworking magazine reviewed and tested thirty saw-blades. We’re proud to say that the TS-2000 combo blade was rated excellent in all areas. It even ran truer than the most popular blade on the market. The TS-2000 combo blade isn’t only the choice of many seasoned woodworkers, it’s the Editor’s Choice, given to Ridge Carbide by American Woodworker magazine. And after being put to the test again, against eighteen competitors, Ridge Carbide wears this honor proudly.

Features

C-4 Micro-Grain carbide tips 1/3 larger than the best known blades
Rips and crosscuts hard and soft wood, smooth as a baby’s bottom
No bottom splintering on plywood veneers
Carbide teeth are ground to a 1200 grit micro finish for razor sharpness
20-25 blade sharpenings possible

Specifications

Diameter: 10"
Bore: 5/8"
Tooth Count: 40
Tooth Geometry: FTG
Kerf: .125"